SYNTECH POLIUREA PRIMER – EPOXY METAL is a two-component primer based on epoxy resins free from solvents, used to promote adhesion, as a surface sealant for concrete, applied as a substrate for works with polyureas on metal surfaces and epoxy and polyurethane coatings.
Use wearing protective gloves
Shelf-life: 12 months
Use wearing protective glasses
Mixing ratio: 2:1 (in peso) _
Density: 1.1 (A) / 1.0 (B) ± 0.1 g/cm³
Dosage: 150 - 200 g/m²
Time before second coat
max 10 h
Hard to touch
- Transparent / Neutral
- Can 10 kg [A]
- Can 5 kg [B]
- Kit: 1 Can 10 kg [A] + 1 Can 5 kg [B]
Approximately 0,20 kg of SYNTECH POLIUREA PRIMER – EPOXY METAL for every square metre of surface to be treated.
Adhesion promoter, surface sealant for concrete, to be applied as a substrate for works with polyureas on metal surfaces and epoxy and polyurethane coatings.
The application must take place on a dry and degreased surface; the substrate must not have crumbly or detached parts and with a degree of humidity that must not exceed 5%.
Preparation of the substrate may require some types of mechanical action: Smoothing,
bush-hammering, shot peening, hydro-washing. Other mechanical actions that can make the support suitable.
The individual components must be mixed carefully until a homogeneous mass is obtained. The material can be applied by roller, brush or spray by means of special airless machines, even in two coats. The temperature of the support must always be at least 3°C higher than the dew point temperature. Minimum application temperature +5°C, maximum temperature +35°C.
- Low pressure airless nebulizer
- Paint roller
- Thinner for resins
- Metal surfaces
Avoid contact with skin and mucous membranes. Use appropriate protection, in particular, goggles and gloves. Do not inhale any vapours deriving from the processing of the product and if possible, ventilate the work areas.