Appearance: Thick liquid
Protective decorative enamel, with satin effect, monocomponent, high technical content, very resistant to the action of UV rays; based on polyurethane polymer mixtures and acrylic modified with Teflon, in aqueous emulsion. Perfect for finishing concrete surfaces intended for permanent contact with water (swimming pools, fountains, ornamental basins, channels, artificial ponds, tanks, etc. ). It is provided in the standard colours Light Blue and White, on request it can be supplied in other colours.
Density: 1.40 (± 0.05) kg/dm³
Shelf-life: 12 months
Temperature of use: +5 / +35 °C
Use wearing protective gloves
Maximum humidity of the support
Hard to touch
53 ±0.05 %
- Light blu
- Pail 14 l
SMERALD PISCINE is a special mixture of polyurethane-acrylate Teflon coated resins, in aqueous emulsion, particularly resistant to light, water, chlorine and the usual sanitising agents. Modified with unalterable high coverage pigments and special additives, effectively protected against UV radiation, assisted by peculiar radical catchers, it is characterised by high adhesion to the support, high elastic performance, excellent coverage capacity with only two coats of application, and absolute absence of toxic solvents of any kind.
Apply from 0.30 to 0.40 liters of SMERALD PISCINE per square metre of surface to be painted.
Specially formulated for painting pools, ornamental basins, channels, fountains, ponds, tanks, and any cement support strongly and permanently in contact with water.
The surfaces of application should be clean, free of any soiling, crumbling and non-adhering parts, or non-absorbent, dust, pre-existing paints, etc.
SMERALD PISCINE can be applied by brush, roller or airless (membrane type) with nozzle 1.5 -2 mm in diameter. Always use two coats, with intervals of at least 2/4 hours one from the other, for a consumption not less than 200 g/m² per coat (approximately 450 g/m² total consumption). During spreading, if the product needs it, it can be diluted exclusively with water, not exceeding the dilution of 5%-10% by weight of the product. Do not dilute with solvent.
Carry out the application in good weather conditions with temperatures higher than 5-8 °C, for rapid drying. On large surfaces it is recommended to apply the product from the same production lot. Proceed always wet on wet to avoid signs of resumption.
- Paint roller
- Cement-based or lime-based mortars
- Prefabricated concrete
- Rock walls
As for all products made from resins in aqueous emulsion, to avoid defects in filming, the application temperature must be between +5°C and +35°C with relative humidity not exceeding 60%-70%. The application should be avoided in case of direct exposure to sunlight and significant ventilation.
The specified consumption must be respected (use 1 kg of product to pigment maximum 2.5 m² surface!). If the applied amount is less than the recommended minimum, the polymerization process (which makes it elastic adhesive and painting) would be compromised.
Want to know more about our products?
It is the high strength version of SYNTECH PAVICROM. Suitable to coat sewers and supports in contact with abrasive chemicals.
It is classic epoxy resin for coloured protective coatings (clear version: SYNTECH PAVISHEER) and dust-proof treatments of industrial flooring and surfaces in concrete. Efficient, reliable and cheap! Recommended!