Appearance: Thick liquid
Paint based on acrylic resins in aqueous emulsion, for interiors and exteriors, protective lamellar structure which, in addition to having an aesthetic effect, allows maximum filling, transpiration and very high resistance to mechanical and chemical light. The high coverage and expandability make this product extremely easy to apply. The special acrylic resins that compose it allow to obtain a film characterized by a rapid insensitivity to water even during the drying phase, with a consequent reduction of the "snail effect" in the event of atmospheric events.
Density: 1.63 g/cm³
Shelf-life: 12 months
Temperature of use: + 5 / + 35 °C
To be applied in two coats
Hard to touch
Resistance to abrasion
cat. 1 _
- Pail 14 l
From 0.20 to 0.30 liters of PROTECH AC-P for each square meter of surface to be painted.
Protective and decorative finish painting of walls, facades, concrete products, plasters, masonry, natural stone, porous substrates in general.
For old plasters, pay particular attention to the old pre-existing paints, which must be removed by careful scraping and brushing in order to obtain a healthy and non-friable support; then proceed with the application of PROTECH FIX AC fixative. When applying on new plasters, it is good practice to insulate the base with acrylic insulator or even better with a white or neutral microemulsion fixative. Avoid windy or cold days when applying. Do not apply on fresh or particularly alkaline substrates, respect a minimum carbonation period of at least four weeks.
On large surfaces it is recommended to apply product from the same batch and always proceed wet on wet to avoid signs of recovery. Never operate with temperatures below + 5 ° C. Rainy weather, excessive atmospheric humidity and temperatures below + 8 ° C can greatly compromise drying with the possibility of washing off by rainwater even after several days. .
DILUTION (by volume with drinking water)
1st COAT: 15% a crossed coat or two coats 12-24 hours apart
2nd COAT: 10%
1st COAT: 10%
2nd COAT: 10%
SPRAY (through specific equipment)
1st COAT: 15/25%
2nd COAT: 15/25%
To avoid filming defects, being resin-based products in aqueous emulsion, the application temperature must be between + 5 ° C and + 35 ° C with relative humidity not higher than 60/70%. Do not apply under the direct action of the sun and wind. Do not apply on fresh or particularly alkaline substrates, respect a minimum drying period of the substrate of at least four weeks. It is also advisable for colored, not to use on large surfaces dyed with different production batches as slight differences between batch and batch are technically possible. Please check the color before application as we will not respond to any disputes regarding the shade of the applied product.
- Low pressure airless nebulizer
- Paint roller
- Cement-based or lime-based mortars
- Prefabricated concrete