An anti-shrinkage, pourable, self-levelling, super-adhesive micro-mortar, based on high-strength cements, super-pozzolanic fillers, polymeric stabilisers and anti-shrinkage agents. Aggregates with a maximum size of 0.35 mm. Ideal for filling joints (gaps and/or interstices) in urban paving made of porphyry or stone slabs, even of large dimensions. For filling cracks and lesions on concrete and masonry structures.
Pot-life: 60 min
Shelf-life: 12 months
Temperature of use: +5/+35 °C
Maximum diameter of aggregate: 0.50 mm
Flexural strength at 01 day
> 8 N/mm²
No bleeding according to UNI 8998
Compressive strength after 07 days
> 65 N/mm²
> 12 _
Compressive strength after 01 day
> 35 N/mm²
Compressive strength after 28 days
> 80 N/mm²
> 2.5 N/mm²
Flexural strength after 28 days
> 13 N/mm²
Flexural strength after 07 days
> 11 N/mm²
- Bag 25 kg
- Pallet: 50 x (Bag 25 kg)
GROUT FILL achieves fluid and hyperfluid workability even with very low water / cement ratios (<0.4), thus resulting perfectly homogeneous, pourable, self-leveling and without water exudation phenomena. The very fine granulometry of the aggregates allows the perfect filling of spaces and particularly narrow discontinuities (<0.5 cm). The capillary absorption of the applied micro-mortar is very low, allowing great resistance to freeze-thaw cycles and washout. GROUT FILL achieves extremely high mechanical performance and is rich in microsilicates with pozzolanic activity and special additives that make it extremely durable even if positioned in particularly aggressive environments (due to contamination by chlorides, sulphates, marine atmospheres, fuels and automotive oils).
Approximately 1800 kg of GROUT FILL for each cubic metre of volume to be filled.
Filling the joints (vanishing points) in urban floorings in porphyry, stone slabs etc., in new installations and in the reinforcement of existing installations. Anchorages and rigid seals in general.
Remove the soilings, the crumbling and non-adhering parts and saturate beforehand with water.
Pour about 2/3 of the required mixture water in the mixer (about 3.5 -4 litres total per bag); gradually add the product and the water still required to get the desired consistency. Continue mixing until you obtain a homogeneous, lump-free mortar. Pour the compound thus obtained in the vanishing points to be filled.
- Pour out
- Floor screed
- Porphyry and natural stones
Do not apply in the presence of stagnant water and direct solar irradiation, in anticipation of atmospheric precipitation and/or sudden drops in temperature.
Treat the hardening and the damp protection fresh mortar placed on site .
Want to know more about our products?
Power additive to create reinforced grout, injectable, to add to cement or hydraulic lime.
Cement grout (binary mix without aggregates), slightly expansive, ready for injection with low pressure or dropped into walls, with the sole addition of water. You are advised to use in walls built before 1900.
Micro-cement mortar, injectable, slightly expansive, for wall reinforcement and cavity filling, to use in grout solutions if the cavities are big or if high performance must be achieved.
Hydraulic lime based grout (binary mix without aggregates), slightly expansive, ready for injection with low pressure in walls, with the sole addition of water. Perfect for monument restorations of historic works.
Hydraulic lime based micro-mortar, injectable, slightly expansive, for wall reinforcement and cavity filling, to use in grout solutions if the cavities are big or if high performance must be achieved.