CONSILEX NO-RUST

Corrosion inhibitor by impregnation for concrete structures

Code: CSX.0247

Components: 1

Appearance: Liquid

CONSILEX NO-RUST is a powerful non-toxic corrosion inhibitor, to be applied to the surfaces of concrete structures and which, thanks to its particular chemical nature, migrates within the conglomerate and deposits on its particular internal reinforcement substances that preserve their integrity over time, by inhibiting oxidation phenomena.

Linee di appartenenza

General characteristics

density

Density: 1.03 kg/dm³

shelf-life

Shelf-life: 24 months

solvent-free

Solvent-free

temperature-of-use

Temperature of use: >0 °C

use-wearing-protective-gloves

Use wearing protective gloves

Technical specifications

pH

9.0-9.5 _

The product doesn't create film

Available colours

- Amber

Packaging and dimensions

- Plastic can 10 kg

- Plastic can 25 kg

- Plastic can 5 kg

Characteristics

CONSILEX NO-RUST performs its function effectively based on the migration phenomenon, which allows it to deposit on the reinforcement of the treated structure of particular corrosion inhibiting agents, even applied to the outer surface of the structure itself!

The particular formulation of CONSILEX NO-RUST allows its effectiveness not to be compromised by the presence of high levels of chlorides in the conglomerate. Alternative nitrite-based products, indeed, in the presence of chlorides, they may even have a negative effect on the corrosion of the reinforcing rods. CONSILEX NO-RUST, on the other hand, can be used effectively on concretes whose irons have already started to suffer corrosive effects and partial oxidation, also due to chlorides.

Consumption

Apply from 0.15 to 0.35 kg of CONSILEX NO-RUST per square metre of surface to be treated.

Use fields

Preventive protection of existing concrete structures, such as public works, road works, buildings, hydraulic works, etc.

Preparation of supports

Thoroughly clean the support before applying the product, removing traces of fats, oils, dirt, incrustations, fouling, etc. Remove any paints, coatings, films or membranes that may be present on the surface: the product works by penetration, so it must come into direct contact with the surface of the concrete.

Use method

Spray-apply on the surfaces to be treated. In the case of structures for which there is a risk that corrosion phenomena are already in progress, apply two coats. Allow the surface to dry for a few minutes after application.
If you squirt the product accidentally on the glasses, paints, frames, etc., simply wash with abundant water.

In case the treated surface should then be treated or coated with paint or other coatings, please note that a thin layer of inhibitor may be deposited on the surface. In this case, wash with plenty of water and carry out preliminary adhesion tests on the coating that you intend to use. In case the tests fail, proceed with hydrocleaning or slightly sanding to remove any residue. Carry out preliminary tests in this case as well.

Application methods

- Suffuse

- Low pressure airless nebulizer

- Sprayer

Tool cleaning

- Water

Permitted supports

- Concrete

- Cement-based or lime-based mortars

- Prefabricated concrete

Contact us now

Vuoi saperne di più sui nostri prodotti?

Attention, correctly compile this field.
Attention, enter a valid email address.
Attention, correctly compile this field.

By submitting I accept the privacy policy

Attention, correctly compile this field.

Subscribe to the newsletter

Share

Products on display

  • Opus Dry
  • Grout Power
  • Osmocem