Premixed based on hydraulic lime, special sulfur aluminate binders, water retainers, shrinkage compensators and reducers of the water/binder ratio, used for fixing and anchoring, in masonry, connectors, inserts, bars, brackets, grouting of the joints, tacking of lesions. It is a product with accelerated setting and hardening, with setting start at 30 ', end setting at 60' and development of mechanical strength already after 90 'of curing. Particularly recommended in the restoration of period and monumental buildings.
Specification for Mortar for Masonry - General purpose rendering/plastering mortar (GP)
Masonry mortars - Masonry mortar for general purposes (G)
Density: 1.97 kg/dm³
Maximum diameter of aggregate: 0.5 mm
Mix with water: 23 - 30 %
Pot-life: 15 min
Shelf-life: 6 months
Temperature of use: +5 / +30 °C
Use wearing protective gloves
> 1.0 N/mm²
< 0.50 kg•h^0.5/m²
Compressive strength after 01 day
> 13 MPa
Compressive strength after 1,5 hours
> 4 MPa
Compressive strength after 28 days
> 20 MPa
Flexural strength after 28 days
> 6 MPa
Flexural strength at 01 day
> 4 MPa
Hard to touch
Permeability to water vapor
≤ 35 _
> 12 _
Reaction to fire
Static elastic modulus
- Light gray
- Bag 25 kg
- Pallet: 50 x (Bag 25 kg)
The particularly fine constituent materials allow adequate anchoring even in the presence of a small space between hole and connectors. By mixing ANCHORSANA FIX with different water contents, the product passes from thixotropic consistencies (23% water) to fluid gel consistencies (30% water), allowing any type of anchoring, from overhead to inclinations towards the bass. The product does not contain resins and solvents and can also be used indoors, subject to the usual precautions necessary when handling materials based on alkaline and irritating powders such as lime (use suitable personal protective equipment, such as gloves and protective goggles).
Approximately 1.6 kg of ANCHORSANA FIX for each cubic decimeter of volume to be filled.
Fixing and anchoring, in masonry bodies, of rigid connectors, jib connectors, inserts, bars with improved adherence, anchors. It develops great adhesion on materials of different nature: metal, fiberglass, basalt.
Blow with compressed air and forced suction of the housing holes. The application surfaces must be clean, free of dirt, moving, crumbly and incoherent parts, dust, etc., suitably saturated with water until reaching the condition of "saturated with dry surface".
Pour about 2/3 of the mixing water into the mixer; gradually add ANCHORSANA FIX and the water still required, continuing to mix, until a homogeneous, lump-free mixture of the desired consistency is obtained. Apply with a trowel or by casting. The mixing water indicatively required is equal to 23% by weight for thixotropic doughs, and to 30% by weight for doughs with a plastic-fluid consistency.
- Brick trowel
- Pour out
- Cement-based or lime-based mortars
- Mixed walls (bricks and stones)
- Stone walls
- Floor screed